The band saw is a table saw that allows the cutting of wood and its derivatives, the edging of wooden boards and fretwork.
The amateur is entitled to think that the acquisition of a wood combination will be enough to carry out all the carpentry work but he is wrong... The circular saw will show him shortcomings both by its reduced cutting height and the inability to make circular cuts. The thicknesser-planer will only be able to accept wood matching its own width. The band saw is an essential woodworking machine because it offers the possibility of fretwork and a large cutting height capacity! Our range is very wide, the choice very easy: for DIY or professional, everyone will find their band saw adapted to their work and their workshop!
Whether it is light or heavy, working with a band saw must always be stable! Do not hesitate to fix it to a workbench for small models using clamps or other so that it cannot move during cutting. Same advice for wood, avoid overhang, provide sideboards to support it at the back of the machine so that it does not tip over. There is no shortage of safety features on a bandsaw, such as the door switch that will prevent the machine from starting if the door is not properly closed, the upper and lower blade guides that will protect you from the blade, the saw table used to support the pieces of wood must be well sized especially for sawing firewood, essential safety features that must not be modified in any way! The power and speed of the electric motor must be adapted according to the type of cut and the width of the blade.
For each model, we offer band blades for fretwork or cutting, different blade widths that will allow the user to easily make curves or straight cuts.
This small JET JWBS-9X bandsaw will offer amateurs the possibility of cutting panels with dimensions less than or equal to 230mm, over a maximum height of 80mm.
JET JWBS 10-M band saw with a capacity of 100 mm and equipped with a large table allowing you to work on already substantial sections.
The JET JBS12-M band saw is only available single-phase. Its 305 mm wheel and its blade width of 5 to 16 mm allow fretwork at a cutting height of 180 mm. Its cast iron table tilts 45 degrees and its cutting depth is 305 mm.
The JET JWBS-15-M bandsaw has a 375mm flywheel and a blade width of 5-25mm allowing for fretwork over a cutting height of 356mm. Its cast iron table tilts 45 degrees and its cutting depth is 359 mm.
The JET JWBS-15-M bandsaw has a 375mm flywheel and a blade width of 5-25mm allowing for fretwork over a cutting height of 356mm. Its cast iron table tilts 45 degrees and its cutting depth is 359 mm.
JET JWBS-20 400V band saw allowing a cutting height of 300 mm.
The JWBS-18 bandsaw has a 460mm flywheel and the 32mm blade width allows for edging over a cutting height of 406mm, the cast iron table tilts 45 degrees and the depth of cut is 457 mm.
The JWBS-18 bandsaw has a 460mm flywheel and the 32mm blade width allows for edging over a cutting height of 406mm, the cast iron table tilts 45 degrees and the depth of cut is 457 mm.
