Reference: KPD3908204021
Carbon brushes and brush holders 42 x 28 x 30 mm, Ref. 3908204021, for Scheppach AB1900 demolition hammer

The carbon brushes and brush holders for Scheppach AB1900 demolition hammer – Ref. 3908204021 are designed to ensure the electrical supply to the motor and keep the carbon brushes correctly positioned against the commutator.
The carbon brushes, also known as motor brushes, transmit electrical current to the rotating part of the motor through their continuous contact with the commutator.
The brush holders keep the carbon brushes correctly positioned and guide them as they wear, while ensuring proper contact with the commutator through spring pressure.
Carbon brushes and brush holders in good condition help ensure consistent electrical current transmission, stable motor operation and optimal demolition hammer performance.
As carbon brushes are wear parts, it is recommended to inspect them regularly and replace them in pairs when worn.
The carbon brushes and brush holders for Scheppach AB1900 demolition hammer – Ref. 3908204021 should be replaced in the following cases:
Carbon brushes are severely worn or have become too short
Motor is difficult to start or no longer starts
Intermittent demolition hammer operation
Loss of power during use
Unexpected motor shutdowns
Excessive sparking at the commutator
Cracked, broken or deformed brush holders
Carbon brushes slide with difficulty or become stuck in their housings
Damaged retaining springs or insufficient spring pressure
Poor electrical contact causing irregular motor operation
It is recommended to replace both carbon brushes at the same time to ensure even wear and proper contact with the commutator.
When replacing them, it is also important to check the condition of the commutator and brush holders. A damaged commutator or incorrect brush guidance can cause premature wear of the new parts.
Warning: Always disconnect the demolition hammer from the power supply before carrying out any maintenance or repair work.
Scheppach AB1900
Scheppach AB1900 SE
Scheppach MPP1900
Carbon brushes and brush holders 42 x 28 x 30 mm, Ref. 3908204021, for Scheppach AB1900 demolition hammer