Working at the router requires a lot of accessories that must always be at hand.
Already if you have a router, always make sure that it has all the basic safety: a housing with a bar guide, a tree with all its rings, hat and screw at the end of the shaft to tighten the tools.
Then, to have fun is to have at hand: grasshoppers, a ruler, a caliper, etc.
If you decide to work on the tree, that is to say, perform fretwork or copying, get the tree work guide, ball guide rings or multi-curved template is almost essential.
And as a wood router can also work as a router, remember that the chuck carbide router bit exists, is inserted at the end of the shaft and allows a small molding quickly.
Set of 10 millimeter rings for spindle moulder bore 30 mm
Set of 10 intermediate collars for spindle moulder bore 30 mm
Set of different rings giving a total height of 130 mm for spindle moulder's shaft
Set of 2 reduction bush with collar to put a tool bore 30 mm on spindle moulder 20 mm
Set of 2 reduction bush with collar to put a tool bore 50 mm on spindle moulder 30 mm
Here is a device that allows you to easily adapt your strawberries défonceuses on your tree spinner Ø 30 mm.
Mandrel which will allow you to easily adapt your router bits on your router shaft Ø 30 and 50 mm with M16 thread.
12 mm pliers for router cutter chuck M14 and M16
Collet 8 mm for mandrel drill bit shaft end
The "Multicurve" or "Multichantournage" allows you to quickly and very cleanly carry out all your fretwork jigs with a router or router and that with extreme ease!
The Quick horizontal toggle clamp makes it possible to safely hold the pieces of wood to be machined
Safety guide with a length of 700 mm in aluminum adapted to the small spindle moulders model
Security Guide a length of 700 mm aluminum adapted to the model of a spinning top or average combined model. (also available in length of 600 for smaller models and 1000 mm for the larger rotors).
Safety guide with bars for spindle moulder length 1000 mm
Tightening screw length 55 mm of the router shaft in M16 Holzmann FS160L, Jean l'ébéniste MX5108 and Bernardo T500PF
M16 spindle moulder shaft tightening nut for Holzmann FS160L, Jean l'ébéniste MX5108 and Bernardo T500PF
T-bushing diameter 70 mm and threaded screw M16 for spindle moulder shaft 50 mm
Go from a 20 mm shaft to a 30 mm shaft using this sleeve fitted with spacer rings.
