Working at the router requires a lot of accessories that must always be at hand.
Already if you have a router, always make sure that it has all the basic safety: a housing with a bar guide, a tree with all its rings, hat and screw at the end of the shaft to tighten the tools.
Then, to have fun is to have at hand: grasshoppers, a ruler, a caliper, etc.
If you decide to work on the tree, that is to say, perform fretwork or copying, get the tree work guide, ball guide rings or multi-curved template is almost essential.
And as a wood router can also work as a router, remember that the chuck carbide router bit exists, is inserted at the end of the shaft and allows a small molding quickly.
Set of 10 millimeter rings for spindle moulder bore 30 mm
Set of 10 intermediate collars for spindle moulder bore 30 mm
Set of different rings giving a total height of 130 mm for spindle moulder's shaft
Set of 2 reduction bush with collar to put a tool bore 30 mm on spindle moulder 20 mm
Set of 2 reduction bush with collar to put a tool bore 50 mm on spindle moulder 30 mm
Here is a device that allows you to easily adapt your strawberries défonceuses on your tree spinner Ø 30 mm.
Mandrel which will allow you to easily adapt your router bits on your router shaft Ø 30 and 50 mm with M16 thread.
12 mm pliers for router cutter chuck M14 and M16
Collet 8 mm for mandrel drill bit shaft end
The Quick horizontal toggle clamp makes it possible to safely hold the pieces of wood to be machined
Screw M14 for 45° chamfer cutter head
T-bushing diameter 70 mm and threaded screw M16 for spindle moulder shaft 50 mm
Go from a 20 mm shaft to a 30 mm shaft using this sleeve fitted with spacer rings.
