Leman Spindle End Sleeve and Screw for Ø30 mm Spindle Moulder

The Leman spindle end sleeve and screw, ref. 969.5.040.30.14, is designed for mounting and securing a cutter block on a 30 mm diameter spindle moulder shaft.

The set includes the spindle end sleeve and its M14 × 2.00 hex socket fixing screw.

The sleeve has a height of 18 mm and is designed for use with a cutter block featuring a Ø40 × 6 mm counterbore.

For Ø30 mm Spindle Moulder Shafts

This Leman sleeve is designed for a 30 mm diameter spindle moulder shaft. It is fitted at the end of the spindle to allow the compatible cutter block to be correctly mounted and secured.

The supplied hex socket screw features an M14 thread with a 2.00 mm pitch.

18 mm High Spindle Sleeve

The sleeve has a height of 18 mm. Its flange is designed for cutter blocks featuring a 40 mm diameter × 6 mm deep counterbore.

These dimensions are essential for correct installation. Before ordering, check the specifications of your spindle moulder shaft and the cutter block on which the sleeve will be used.

Technical Specifications

Check the Dimensions Before Ordering

IMPORTANT: BEFORE PURCHASING, carefully check the dimensions of your spindle moulder shaft and cutter block.

This model is designed for a Ø30 mm spindle, with an M14 × 2.00 hex socket screw and a cutter block featuring the corresponding Ø40 × 6 mm counterbore.

Visual similarity with an existing sleeve does not guarantee compatibility. Always check the spindle diameter, thread diameter, thread pitch and cutter block counterbore dimensions before ordering.